6168 wind blade structural adhesive is a two component epoxy
adhesive, high-thixotropic, light green, high toughness, high
strength epoxy adhesive.
GRP and FRP adhesive such as fan blade mold, yachts, sports
Characteristics before curing
Typical values range
Appearance light yellow high thixotropic paste
Chemical Composition modified epoxy resin
Density 23℃(GB/T 15223-2008) 1.27
Viscosity (mPa.s) (GB/T 22314-2008) 470000
Appearance light blue thixotropic paste
Chemical Composition modified amine
Density 23℃(GB/T 15223-2008) 1.20
Viscosity (mPa.s) (GB/T 22314-2008) 450000
Appearance light green thixotropic paste
weight ratio A:B=100:50 A:B=100:52±2
Operation time (min, 23℃) 199
Curing time (h, 75℃)6
Characteristics after curing(23℃, 50%RH)
Shear strength (MPa,Al-Al) (GB/T 7124-2008)
Tensile strength (body, 23℃, MPa)58
(ISO 527-2:1993) 44
The tensile modulus (body, 23℃,GPa)
(ISO 527-2:1993) 4.82
T- peel strength(N/mm, Al-Al)(GB/T 1692-2008)
distortion temperature(℃) 69
glass transition temperature(℃) 75.4
flow(5℃-40℃): 5cmLift not sag
Surface preparation: It can be directly used for non-porous surface. Porous or
absorbent surface should be mixed with a resin liquid filled pores
Mixing: mix with weight ratio of A:B=100:50, the increase or decrease
outside the allowance in the amount of curing agent will accelerate
or reduce the rate of curing, leading to incompletely curing. This
can not be modified again. A and B must be mixed very evenly, until
no turbidity is visible. Yellow A andblue B can be visually
recognized. Special attention should be paid to the bottom and wall
of the mixing vessel. It is very difficult to mix a lot of glue by
hand because of the high viscosity. Mixing equipment is necessary
to ensure a larger amount of glue for industrial use.
Curing: Mixed plastic should be at 20-30 ℃, the surface temperature of the
adhesive material should be controlled not more than 35 ℃. Before
curing, remove the excess glue from the surface sticky. The curing
process, the components should be heated slowly so that the
internal stress of the adherend to a minimum. Thick layer (greater
than 10mm) colloidal curing, need to consider a phased temperature
curing in order to control the impact of concentrated heat.
Temperature test center by layer, helping to set procedures to
improve production efficiency and performance of the adhesive.
Please refer to the MSDS for detailed safety Information.
Order code: Shanghai
A 6168 200kg/ barrel, 2 barrels / box.
B 6168 200kg/ barrel, 2 barrels / box.
Stored in a cool, dry place at 8-28℃ for 24 months