RC Series RC040708 Drawn Cup Needle One-Way Clutch Bearings

RC Series RC040708 Drawn Cup Needle One-Way Clutch Bearings
①Dimension inspection:
(1)Press the bearing into ring gauge (wall thickness≥20mm)
(2)Use go gauge and stop gauge to inspect the internal diameter of the bearing
②Installation:
After the bearing is installed into the seat hole, no additional axial positioning is required. The tolerance of the seat hole is the same as that of the drawn cup needle roller bearing, and the surface roughness of the seat hole should be less than Ra0.8. The internal diameter of clutches is the same as that of drawn cup needle roller bearings and the hardness of the shaft should be HRC63-HRC65
③Working temperature:
Drawn cup needle roller clutches with steel spring can operate in the range of -30 to 120 degrees. Drawn cup needle roller clutches with plastic spring can operate in the range of -10 to 70 degrees.

RC040708 One-way clutch bearings: Is composed of the drawn cup and the plastic retainer;

The retainer may bring the plastic reed also to be possible on the stainless steel reed guidance roller pin, in the addendum circle incline roller conveyer and the roller pin takes the locking arrangement.